[Details]
These hoops are made to accommodate bigger figures like the Titan Heroes, but they'll hold smaller figures, Barbies and other dolls and action figures too.
They come in a strip, with 4 hoops per strip. This will allow you to keep up to 4 figures per strip. Smaller figures will sit with their waste inside the hoop and their arms over the edge; bigger ones will hang on like the dudes in the pictures.
Toys not included!
You can choose the colour from the drop down, but if you're ordering a few and want a mix just add a note to your order.
These are attached to the wall with screws and plugs, which I'll include along with a drilling guide. (You could maybe use Command Strips, but I think if you've got a 6-year-old putting stuff away then you'd be better off with the extra strength of screws.)
I based the size on the need to hold the full range of the 12" Titan figures - the smaller ones like the Spider guy up to The Hulky one, so anything that sits within that range should be fine, but if you're not sure - or if you need them amending for your needs - just give me a shout. (And if you order and then find your stuff doesn't fit, let me know, because I can always tweak the design and swap with you.)
Any other questions just shout.
Cheers
Rob
[Instructions]
Decide where you want your brackets and hold the drilling guide in place to mark the wall.
Drill a 6mm hole at each cross and insert a red Rawlplug (included) into each hole.
Screw a screw into each one so that the head of the screw sits 5mm from the wall surface.
Fit the bracket over the screws.
If it’s a bit loose, tighten the screws a quarter turn at a time till it’s not.
If it’s a bit tight, loosen the screws a quarter turn at a time till it’s not.
[Processing]
These will usually take 3-4 days to produce and dispatch.
[Details]
These hoops are made to accommodate bigger figures like the Titan Heroes, but they'll hold smaller figures, Barbies and other dolls and action figures too.
They come in a strip, with 4 hoops per strip. This will allow you to keep up to 4 figures per strip. Smaller figures will sit with their waste inside the hoop and their arms over the edge; bigger ones will hang on like the dudes in the pictures.
Toys not included!
You can choose the colour from the drop down, but if you're ordering a few and want a mix just add a note to your order.
These are attached to the wall with screws and plugs, which I'll include along with a drilling guide. (You could maybe use Command Strips, but I think if you've got a 6-year-old putting stuff away then you'd be better off with the extra strength of screws.)
I based the size on the need to hold the full range of the 12" Titan figures - the smaller ones like the Spider guy up to The Hulky one, so anything that sits within that range should be fine, but if you're not sure - or if you need them amending for your needs - just give me a shout. (And if you order and then find your stuff doesn't fit, let me know, because I can always tweak the design and swap with you.)
Any other questions just shout.
Cheers
Rob
[Instructions]
Decide where you want your brackets and hold the drilling guide in place to mark the wall.
Drill a 6mm hole at each cross and insert a red Rawlplug (included) into each hole.
Screw a screw into each one so that the head of the screw sits 5mm from the wall surface.
Fit the bracket over the screws.
If it’s a bit loose, tighten the screws a quarter turn at a time till it’s not.
If it’s a bit tight, loosen the screws a quarter turn at a time till it’s not.
[Processing]
These will usually take 3-4 days to produce and dispatch.
