[Details]
This is a 3D printed Now Spinning display shelf for records, made from the bioplastic, PLA. I'll provide screws and a template for drilling, but if you'd rather have Command Strips just add a note to your order. This one's larger than the standard shelves.
It measures 19.5cm wide, 2.9 cm tall and 3.4cm deep. (That's about 7 11/16" x 1 1/8" x 1 3/8" in old money.)
I can also produce custom orders so let me know if you can't see what you're looking for.
Any questions just give me a shout.
Cheers
Rob
[Instructions]
Use the drilling template to mark where you’ll need to drill. Use a spirit level to ensure they’re level. Drill two 6mm holes and insert a Rawlplug into each. Screw the screws in so the surface of the head is 5mm from the wall and slide the Now Playing shelf into place. If it’s a bit loose, tighten the screws a quarter turn at a time. If it’s a bit tight, loosen them slightly.
[Processing]
These will usually take 3 or 4 days to make.
[Details]
This is a 3D printed Now Spinning display shelf for records, made from the bioplastic, PLA. I'll provide screws and a template for drilling, but if you'd rather have Command Strips just add a note to your order. This one's larger than the standard shelves.
It measures 19.5cm wide, 2.9 cm tall and 3.4cm deep. (That's about 7 11/16" x 1 1/8" x 1 3/8" in old money.)
I can also produce custom orders so let me know if you can't see what you're looking for.
Any questions just give me a shout.
Cheers
Rob
[Instructions]
Use the drilling template to mark where you’ll need to drill. Use a spirit level to ensure they’re level. Drill two 6mm holes and insert a Rawlplug into each. Screw the screws in so the surface of the head is 5mm from the wall and slide the Now Playing shelf into place. If it’s a bit loose, tighten the screws a quarter turn at a time. If it’s a bit tight, loosen them slightly.
[Processing]
These will usually take 3 or 4 days to make.
